Omega Engineering OMB-NETSCAN 1500 User Manual page 218

Configuration Aspects for Programmers
7 - End Scan Pointer This field represents the location in the current trigger block that the end scan occurred.
This pointer will always be relative to the trigger point. Since the end scan must always occur after the trigger
event this pointer will always be greater than 0. If the end scan has not yet occurred at the time of the U6 query,
this field will have the value of -0999999. This field will always be the same as the Stop Scan Pointer unless a
post-stop count is specified (
Pointer by the value of the post-stop count.
8 - Block Status This field represents the status of the current trigger block. If the current trigger block is still
being acquired, the value of this field will be 00. If the current trigger block has been completely acquired and
has terminated normally the value will be 01. If, however, the current trigger block has pre-maturely terminated
(because of user intervention) the value will be 02.
Trigger blocks are not assigned a trigger block number per se. Trigger block numbers are relative to the read
and write blocks respectively. The current trigger block always refers to the trigger block that is currently being
read. For example, the current read trigger block is always trigger block 1. Conversely, the current write trigger
block is always the value of Blocks Available in the Buffer Status String. With this in mind, look at the
following example a of Buffer Status String response.
The following table describes the fields for the
reference the previous figure has been repeated.
Field Response
1 0000000
2 0000000
3 -0999999
4 00:00:00.000,
00/00/00
5 -0999999
6 00:00:00.000,
00/00/00
7 -0999999
8
C-22
command) in which case the End Scan Pointer will be greater than the Stop Event
Y
U6
Example of Buffer String when the Acquisition Buffer is Empty
Implication
No trigger blocks available.
No scans are available.
The current read pointer is undefined.
The trigger time stamp is undefined.
The stop event pointer is undefined.
The stop event time is undefined.
The end scan pointer is undefined.
00 The current trigger block is not complete.
response when the acquisition buffer is empty. For ease of
Appendix C
NetScan User's Manual