Bottom Cover Assembly - Toshiba Satellite R10 Maintenance Manual

4 Replacement Procedures
4.8

Bottom cover assembly

Removing the bottom cover assembly
The following describes the procedure for removing the bottom cover assembly. (See
Figure 4-10 and 4-11.)
1. Disconnect the touch pad cable from the connector CN3201 on the system board.
2. Close the display and turn the computer upside down.
3. Remove the following screws securing the bottom cover assembly.
M2.0x6.0B
M2.0x3.0B
4. Pull up to remove the bottom cover assembly from the computer.
Satellite R10 Maintenance Manual (960-509)
CN3201
Figure 4-10 Removing the touch pad cable
FLAT BIND screw
S-THIN FLAT BIND screw x2 (Described as "3" in figure)
4.8 Bottom cover assembly
Touch pad cable
x19 (Described as "6" in figure)
4-21