Lcd Harness Holder - Toshiba Satellite R10 Maintenance Manual

4.16 LCD harness holder

4 Replacement Procedures
4.16 LCD harness holder
Removing the LCD harness holder
The following describes the procedure for removing the LCD harness holder. (See Figure
4-26.)
1. Disconnecting the USB harness from the connector CN4612 on the system board
and from CN4612 on the CN board, turn up the insulator and pull out the USB
harness from the guide of LCD harness holder.
2. Disconnect the LCD harness from the connector CN5501 on the system board
and pull out the LCD harness from the LCD harness holder.
3. Disconnecting the CN board harness from the connector CN9512 on the system
board and from the connector CN9520 on the CN board, pull out the CN board
harness from the guide of LCD harness holder.
4. Disconnecting the QI board cable from the connector CN9521 on the CN board
and from the connector CN9530 on the QI board, pull out the QI board cable from
the guide of LCD harness holder.
5. Remove the following screws securing and remove the LCD harness holder.
M2.0x6.0B
4-38
FLAT BIND screw
4 Replacement Procedures
x2
Satellite R10 Maintenance Manual (960-509)