Base Assembly And Cover Assembly - Toshiba PORTÉGÉ M700 Maintenance Manual

4 Replacement Procedures

4.14 Base assembly and Cover assembly

Removing the base assembly and cover assembly
The following describes the procedure for removing the base assembly and cover assembly.
(See Figure 4-24 to 4-26.)
1. Remove the following screw.
• M2.0×4.0B
2. Disconnect the touch pad cable, LCD cable and digitizer cable from the connector
CN3240, CN5601, and CN9540 on the system board.
LCD cable
(connected to CN5601)
Digitizer cable
(connected to CN9540)
Figure 4-24 Removing the base assembly and cover assembly (1)
4-42 [CONFIDENTIAL]
4.14 Base assembly and Cover assembly
BIND screw
M2.0×4.0B BIND
PORTÉGÉ M700 Maintenance Manual (960-661)
×1
Touch pad cable
(connected to CN3240)