Toshiba Satellite R10 Maintenance Manual page 241

4 Replacement Procedures
5. Remove the following screws fixing the HDD holder.
M3.0x4.0S
6. Detach the HDD holder from the HDD.
HDD holder
(HDD frame and laminate)
M3.0x4.0S
FLAT BIND
Installing the HDD
The following describes the procedure for installing the HDD. (See Figure 4-5 and 4-6.)
CAUTION: HDD frame and laminate can not be reused. If you detach the laminate
package from HDD frame, be sure to use a new HDD frame and
laminate package when replacing.
1. Install the HDD holder to the HDD and secure it with the following screws.
M3.0x4.0S
2. Connect the HDD FPC to the connector CN1800 on the system board and the
connector of the HDD assembly.
3. Set the HDD assembly to the HDD slot from the opposite side of the connector.
4. Insert the HDD assembly into the HDD slot of computer.
5. Install the HDD slot cover and secure it with the screw (with e-ring).
Satellite R10 Maintenance Manual (960-509)
FLAT BIND screw
Figure 4-6 Removing the HDD holder
FLAT BIND screw
x4
M3.0x4.0S FLAT BIND
HDD
x4
4.5 HDD
4-15