Toshiba Satellite R10 Maintenance Manual page 255

4 Replacement Procedures
Installing the MDC / modem cable
The following describes the procedure for installing an MDC / modem cable. (See Figure
4-16 and 4-17.)
1. Connect the modem cable to the connector CN3001 on the system board.
2. Secure the drain cable 2 to the stud of hinge assembly with the following screw.
M2.0x4.0Z
3. Arrange the modem cable inside the insulators and close the insulators.
4. Arrange the modem cable along the guide of mini PCI cover.
5. Secure the drain cable 1 to the stud of system board with the following screw.
M2.0x4.0Z
M2.0x4.0B
6. Connect the modem cable to the connector of MDC.
7. Install the MDC to the connector CN3000 on the system board and secure it with
the following screws.
M2.0x4.0Z
Satellite R10 Maintenance Manual (960-509)
BIND screw
BIND screw
or
LH STICK
BIND screw
4.11 MDC / modem cable
x1
x1
x1
x2
4-29