4 Replacement Procedures
Removing the Digitizer
The following describes the procedure for removing the digitizer. (See Figure 4-42.)
1. Remove the following screws securing the digitizer.
M2.0x3.0Z
2. Slide out the digitizer toward the arrow pointing.
M2.0x3.0Z BIND
Installing the digitizer
The following describes the procedure for installing the digitizer. (See Figure 4-42.)
1. Slide the digitizer into the back pocket of LCD.
Caution: When replacing the digitizer, fit the digitizer into the back of LCD toward the
arrow pointing.
2. Secure the digitizer with the following screws.
M2.0x3.0Z
Satellite R10 Maintenance Manual (960-509)
BIND screw
Figure 4-42 Removing the digitizer
BIND screw
4.28 Digitizer
x3
M2.0x3.0Z BIND
Digitizer
x3
4-63