Lcd Unit & Fl Inverter - Toshiba Satellite R10 Maintenance Manual

4.25 LCD unit & FL inverter
4.25 LCD unit & FL inverter
Removing the LCD unit & FL inverter
The following describes the procedure for removing the LCD unit & FL inverter. (See
Figure 4-37 to 4-39.)
NOTE: When replacing the LCD unit, do not give the hinge portion a strong press. It
may cause the breakage of the hinge assembly.
Also, Use a stand or something under the LCD part to keep the LCD part
level while replacing it.
1. Peel off the mask seals (6 points) from the LCD mask.
2. Remove the following screws securing the LCD mask.
M2.0x6.0B
3. Laying down the LCD to make the LCD and the cover assembly flat, release the
latches and remove the LCD mask.
4. Remove the cross function button from the application switch board.
NOTE: When removing the LCD mask, be careful not to lose the cross function button
because the button is easily removed.
M2.0x6.0B FLAT BIND
4-52
FLAT BIND screw
Figure 4-37 Removing the LCD mask
4 Replacement Procedures
x6
Cross function button
LCD mask
M2.0x6.0B FLAT BIND
Satellite R10 Maintenance Manual (960-509)