Toshiba Satellite R10 Maintenance Manual page 248

4.8 Bottom cover assembly
Figure 4-11 Removing the bottom cover assembly
Installing the bottom cover assembly
The following describes the procedure for installing the bottom cover assembly. (See
Figure 4-10 and 4-11.)
1. Install the bottom cover assembly to the computer.
Note: Install the bottom cover assembly from the i.LINK (IEEE1394) slot first.
2. Secure the bottom cover assembly with the following screws
M2.0x6.0B
M2.0x3.0B
3. Turn over the computer and open the display.
4. Connect the touch pad cable to the connector CN3201 on the system board.
4-22
(6)
(3)
(6) (6)
(6)
(6)
FLAT BIND screw
S-THIN FLAT BIND screw x2 (Described as "3" in figure)
4 Replacement Procedures
(6)
(6)
(6)
(6)
(6)
(6)
x19 (Described as "6" in figure)
Satellite R10 Maintenance Manual (960-509)
(3)
(6)
(6)
(6)
(6)
(6)
(6)
(6)
(6)