Toshiba Satellite R10 Maintenance Manual page 290

4.29 LCD/digitizer harness & Wireless LAN antenna cables 4 Replacement Procedures
4.29 LCD/digitizer harness & Wireless LAN antenna cables
Removing the LCD/digitizer harness & wireless LAN antenna cables
The following describes the procedure for removing the LCD/digitizer harness & wireless
LAN antenna cables. (See Figure 4-43 and 4-44.)
1. Pull out the wireless LAN antenna cables from the guide.
2. Remove the following screws and LCD harness holder.
M2.5x2.8B
3. Remove the following screws and digitizer harness holder.
Unique screw CPU stud screw
M2.5x6.0S
4. Remove the following screws securing the hinge assembly.
M2.5x6.0B
M2.5x6.0S
5. Remove the hinge rear cover from the hinge assembly.
6. Detach the cover assembly from the display cover.
M2.5x2.8B FLAT BIND
M2.5x6.0B FLAT BIND
Digitizer harness holder
4-64
FLAT BIND screw
PSP TIGHT screw
FLAT BIND screw
PSP TIGHT screw
CPU stud
Figure 4-43 Removing the cover assembly
x1
x1
x1
x1
x1
LCD harness holder
M2.5x6.0S PSP TIGHT
Hinge rear cover
Satellite R10 Maintenance Manual (960-509)