Table of Contents
Advertisement
2-3 Settings of the Media Heating System
What Is the Media Heating System?
This machine is equipped with a media heating system that warms the media. You use this mainly to improve ink
adhesion and dry the ink.
The media heating system is composed of the three devices shown in the figure below.
Preheater
This device warms the media before printing.
Print heater
This device is used mainly to improve ink adhesion.
Dryer (drying heater and blower fan)
You use this to speed up drying of the ink.
Drying heater
This warms the media after printing.
Blower fan
This blows moving air onto the surface of the me-
dia after printing.
WARNING
WARNING
WARNING
WARNING
Making the Temperature Setting for the Media Heating System
Procedure
PRE
45 PRINT
DRY
50
PRINT
PRINT
W 2600 mm
SETUP SHEET
By default, simply switching on the power does not make the machine warm up to the preset temperature. Press-
ing
to make the light come on makes them to warm up to the preset temperature.
48
Chapter 2 Operation
Caution: high temperatures.
The platen and dryer become hot. Exercise caution to avoid fire or burns.
Remove any loaded media or switch off the sub power when printing is not being
performed.
The continued application of heat at a single location may cause fire or produce toxic
gases.
Never use media that cannot withstand the heat.
Doing so may result in fire or the release of toxic gases, or may degrade the media.
Never use the platen or dryer for any purpose for which they are not intended,
such as to dry clothing.
Doing so may cause overheating, resulting in fire or accident.
Press
45
The present temperature is displayed.
Press
38
45
45
Use
Use
38
40
40
Press
Press
Press
(Blower fan)
(Drying heater)
.
a second time.
to select the unit.
to make the setting.
to enable the setting.
.
to go back to the original screen.
Advertisement
Table of Contents
