Oki MB441 User Manual page 86

List of the Device Setting Menu Items
Other Redial Tries
Settings
Redial Interval
Block Junk Fax Setting
Ring Response
Dialling Pause Duration
Rx Reduc. Rate
Reduc. Margin
ECM Mode
PreFix
Received Time Stamp
Print Check Message
Fax Service Bit
Setting
Country Code
A/R Full Print
Tone For Echo (For Transmission)
Tone For Echo (For Reception)
H/Modem Rate(For Tx)
H/Modem Rate(For Rx)
Attenuator
Item
Registered Register/Edit
List
Delete
Factory
Default
2 times Sets the number of redial attempts.
Available range: 0 to 9 times.
1 minute Sets the time between redial attempts.
Available range: 1 to 5 minutes.
OFF Sets the mode of Block Junk Fax.
(No Entry) Register/Edit addresses for Block Junk Fax.
Display condition: [Admin Setup]>[Other
Settings]>[Block Junk Fax]>[Setting] is
set to [Mode2].
(Nothing: con- Delete addresses for Block Junk Fax. Dis-
nect Item cell play condition: [Admin Setup]>[Other
and Factory Settings]>[Block Junk Fax]>[Setting] is
default cell) set to [Mode2].
1 ring Sets the number of rings required before
receiving an incoming fax.
2 seconds Sets the dial pause time.
Available range: 0 to 10 seconds.
Auto Sets the reception reduction rate.
24 mm or 3.9 Sets the threshold level of reception
inch reduction.
Available range: 0 to 100 mm
(0 to 3.9 inches).
ON Sets whether to use the error correction
mode.
NULL Sets the dialing prefix. Maximum 40 dig-
its.
OFF Sets whether the time stamp is printed on
incoming faxes.
ON Sets whether the error content is reported
when a transmission error occurs.
OFF If set OFF, some menu items are not dis-
played on the panel.
International Sets the country code.
or U.S.A or
Australia(Sin-
gapore)
ON Sets whether to print the list of the com-
munication results automatically after
every 50 communications.
Disable It only shows, when ServiceBit = ON.
Disable It only shows, when ServiceBit = ON.
33.6 Kbps Sets the default value of the modem
transmission speed while the machine is
sending a fax.
33.6 Kbps Sets the default value of the modem
transmission speed while the machine is
receiving a fax.
10 dB, Range : Enter Attenuator.It only shows, when Ser-
0-15 dB vice Bit = ON.
- 86 -
Description