Changing Network Settings From The Web Page; Encrypting Communication By Ssl/Tls - Oki MB441 User Manual

Changing Network Settings From the Web Page

Changing Network Settings From the Web Page

This section explains how to change the network settings from the machine's web page.
To access the machine's web page, your computer must meet the following conditions:
 TCP/IP is enabled.
 Microsoft Internet Explorer 6.0 or later, Safari 3.0 or later, or Firefox 3.0 or later is installed.
Memo
 Ensure that the security setting of the web browser is set to a middle level, or that cookies are allowed.
 To enter the [Admin Setup] menu, it is necessary to log in as the administrator. The factory default administrator password is
"aaaaaa".
Reference
 Some of the following settings can be performed on other utilities. For details, refer to
Encrypting Communication by
SSL/TLS
You can encrypt communication between your
computer and the machine. Communication is
encrypted by SSL/TLS in the following cases:
 Change of the machine settings from the web page
 IPP printing
 Direct print
 LDAP search
 Send data via SMTP or FTP
 Print received data via SMTP or FTP
Creating a Certificate
You can create a certificate on the web page. The
following two certificates are available:
 A self-signed certificate.
 A certificate created by a certificate authority.
Note
 If you change the machine IP address after you create a
certificate, the certificate becomes invalid. Be sure not to
change the machine's IP address after creating a
certificate.
Access the machine's web page and log
1
in as the administrator.
Select [Admin Setup].
2
Select [Network Manager] >
3
[Security] > [Encryption (SSL/TLS)].
Follow the on-screen instructions to
4
specify detailed settings.
Memo
 The machine's IP address is set to [Common Name].
Click [Send].
5
Check the settings and click [OK].
6
If you are creating a self-signed
7
certificate, follow the on-screen
instructions and close the web page.
Then go to
If you are getting a certificate issued by
a certificate authority, go to step 8.
Follow the on-screen instructions to send
8
a CSR to a certificate authority.
Click [OK].
9
Follow the on-screen instructions to
10
install a certificate from the certificate
authority.
Click [Send].
11
Go to "Enabling
12
Enabling Encryption
After creating a certificate, perform the following
procedure to enable encryption.
When you change the settings from the web
page to enable encryption, communication is
encrypted immediately after that change has
been made.
Perform
1
to 3 to enter the encryption screen.
Select [Enable] for the desired protocol
2
on which encryption is applied.
Click [Encryption Strength Settings].
3
Select the encryption strength and click
4
[OK].
Click [Send].
5
- 156 -
"Network Setting Items" P.
"Enabling Encryption".
Encryption".
"Creating a Certificate"
133.
steps 1