Punching Holes In Copies (Punch Settings) - Konica Minolta bizhub 361 User Manual

Basic copy operations
– When the "Corner" Staple setting is selected.
– Touch [Auto] to automatically determine the stapling position according to the orientation of the
loaded original. If the original length is 11-11/16 inch or less, the long side of the paper is stapled.
If the original length is more than 11-11/16 inch, the short side of the paper is stapled.
– If "Auto" is selected for the stapling position, load the original with the top toward the back of the
machine. If the original is loaded in any other orientation, the stapling will not be correctly
positioned.
– If "Auto" is selected, the stapling position is set at the top or at the left.
– To cancel the setting and select the default, press the [Reset] key.
4
If desired, touch [Original Direction], and then select the setting appropriate for the original.
– For details on specifying the original orientation, refer to
(Original Direction settings)" on page
5
Touch [OK].
The Basic screen appears again.
2.11.5

Punching holes in copies (Punch settings)

!
Detail
In order to be punch holes in the copies, all of the following conditions must be met.
The paper width must be between 7-3/16 inch and 11-11/16 inch.
The paper length must be between 7-3/16 inch and 17 inch.
If a Punch setting is to be selected, select the orientation in which the original is positioned. If an Original
Direction setting is not selected, holes may not be punched in the copies as desired.
For details on specifying the original orientation, refer to
Direction settings)" on page
Note
The Punch settings are available only if the Punch Unit PU-501 is installed on the optional Finisher FS-
522, or if the optional Finisher FS-523 is installed.
Finisher FS-522
Paper weight
Plain paper (16 lb to 24 lb)
Thick paper (24-1/4 lb to 44 lb)
Finisher FS-523
Paper weight
Plain paper (16 lb to 24 lb)
501/421/361
2-20.
"Selecting the original orientation (Original
2-20.
Paper size
2-Hole: 11 × 17 w to 8-1/2 × 11 v/w
3-Hole: 11 × 17 w, 8-1/2 × 11 v
Paper size
2-Hole: 8-1/2 × 14 w, 8-1/2 × 11 w
3-Hole: 11 × 17 w, 8-1/2 × 11 v
"Selecting the original orientation
2
2-60