Konica Minolta bizhub 361 User Manual page 150

Additional copy operations
6
If the original was placed on the original glass, touch [Finish], and then press the [Start] key.
– If the original was loaded into the ADF, printing of the proof copy begins without the screen
appearing confirming that scanning of the original is finished.
A single proof copy is printed.
7
Check the proof copy.
– If the proof copy was printed as desired, continue with step 11.
– To change the copy settings, continue with step 8.
8
Touch [Change Setting] in the screen that appeared when the proof copy was printed.
– To stop copying while the proof copy screen is displayed, press the [Reset] key or the [C] (clear) key.
Otherwise, select the proof copy job to be stopped from the list of jobs in the left panel, and then
touch [Delete]. In the screen that appears, requesting confirmation to delete the job, touch [Yes],
and then touch [OK].
– If no operation is performed within the specified length of time while this screen is displayed, the
copy job being proofed is registered as a stored job and the Basic screen appears again. Jobs are
registered as stored jobs under the following conditions:
When the automatic system reset operation is performed
After one minute (when "System Auto Reset" is set to "OFF")
– For details on stored jobs, refer to
stored if no operation is performed for 1 minute. However, if "System Auto Reset for Proof Copy" is
set to "No", the job is not stored. For details on Reset Settings, refer to
page
– For details on the automatic system reset operation, refer to
(Sleep mode)" on page
– The number under "Number of Sets" in the screen that appeared when a proof copy is printed
indicates the number of sets printed as proof copies/total Number of Sets specified.
– The number under "Total # of Pages Printed" in the screen that appeared when a proof copy is
printed indicates the number of copies printed as proof copies/the number of pages printed in the
proof copy.
9
In the screen allowing you to change the settings, change the copy settings as desired, and then touch
[OK].
To cancel changes to the settings, touch [Cancel].
– If the copy settings cannot be changed, stop printing the proof copy. Next, press the [Reset] key to
cancel the copy settings, and then specify the desired settings.
– To stop copying while the screen for changing the settings is displayed, select the proof copy job
to be stopped from the list of jobs in the left panel, and then touch [Delete]. In the screen that
appears, requesting confirmation to delete the copy program, touch [Yes], and then touch [OK].
– To cancel changes to the settings in the screen for changing the settings, press the [Reset] key while
the screen for changing the settings is displayed to reset the settings to those specified in step 2.
501/421/361
11-26.
1-29.
page 10-11. If "System Auto Reset" is set to "OFF", the job is
"Reset Settings" on
"Automatically conserving energy
3
3-6