Basic Commands (Direct Access); Arm; Disarm - Viper 5706V Owner's Manual

Basic Commands (Direct Access)

Arm

Press and release
The alarm arms, doors lock (if connected), and the siren
chirps and parking lights flash once. The
to confirm and the System Status Icons update. If Valet Mode* is ON,
the doors lock and the
arm the alarm normally.
If a Trigger Zone Fault is detected the siren chirps once again and the
Trigger Zone Fault report** plays.
To Arm and Panic
Press and hold
The alarm Arms (or Locks in Valet) and, after two seconds, sounds
the siren and flashes the parking lights. The
tones play to confirm. Press the

Disarm

Press and release
The alarm disarms, doors unlock (if connected), and the siren chirps
and parking lights flash twice. The
confirm and the system status icons update. If Valet Mode* is ON, the
doors unlock and the
control the system normally.
An alarm report replaces the disarm output if the alarm was triggered.
The siren chirps four or five times and the
the Alarm report.**
14 14
text and tone play. Exit Valet Mode to
VALET
DISARM
text and tone play. Exit Valet Mode to
VALET
text and beeps play
ARMED
PANIC
or button to stop the output.
text and beeps play to
text is replaced by
DISARM
© 2016 Directed. All rights reserved.
ALL
1
6:30
text and siren