Basic Commands (Direct Access); Arm; Disarm - Viper 5606V Owner's Manual

Hide thumbs Also See for 5606V:

Table of Contents

Basic Commands (Direct Access)

Press and release

The alarm arms, doors lock (if connected), and the siren chirps and

parking lights flash once. If Valet Mode* is On, the doors lock without

siren chirps, the alarm is disabled. Exit Valet Mode to arm the alarm

normally.

If a Trigger Zone Fault is detected the siren chirps once again and the

Control Center LED generates a Trigger Zone Fault report**.

To Arm and Panic

Press and hold

The alarm Arms (or Locks in Valet) and, after two seconds, sounds

the siren and flashes the parking lights. Press the

to stop the panic output.

Press and release

The alarm disarms, doors unlock (if connected), and the siren chirps

and parking lights flash twice. If Valet Mode* is on, the doors unlock

without siren chirps. Exit Valet Mode to control the system normally.

An Alarm Report** alert of four or five siren chirps will replace the

normal disarm chirps if the alarm was triggered.

AUX

button

AUX

Table of Contents