Basic Commands (Direct Access); Arm; Disarm - Viper 5701 Owner's Manual

Basic Commands (Direct Access)

No Ghost LED's on

Arm

Press and release
The alarm arms, doors lock (if connected), and the siren chirps and
parking lights flash once. The Arm LED and beeps play to confirm. If
Valet mode* is On, the doors lock and the Arm LED,
fault tone plays. Exit Valet mode to arm the alarm normally.
If a trigger zone fault is detected the siren chirps once again and the
remote will emit a Trigger Zone Fault Report**, the Arm LED,
and a fault tone plays.
To Arm and Panic
Press and hold
The alarm Arms (or Locks in Valet) and, after 2 seconds, sounds
the siren and flashes the parking lights. The ghost LED's flash and
siren tones play to confirm. Press the
output.

Disarm

Press and release
The alarm disarms, doors unlock (if connected), and the siren chirps
and parking lights flash twice. The Disarm LED and beeps play to
confirm. If Valet mode* is On, the doors unlock and the Disarm LED,
LED and fault tones play.
An Alarm Report** will replace the disarm output if the alarm was
10
or
© 2011 Directed Electronics. All rights reserved.
LED and a
LED
button to stop the