Place in
front of
printer lip
STEP 3. It may be a tight fit and require considerable downward pressure to get the cover to set down
completely. Before pressing down, make sure that all cables are clear of the contact area
between the cover and printer.
STEP 4. Reinstall the screws in position 1 and 2, then tighten the screws at positions 3, 4, and 5 (see
Figure 4–5).
STEP 5. Reinstall the Printer Control Panel.
Chapter 4: Removal and Reinstallation Procedures
1.
2.
Figure 4–6. Reinstalling the Right End Cover
3.
4 –7