Figure 4–32. Paper Advance Motor Assembly - Tally T6090 Maintenace Manual

T6090 Maintenance Manual
STEP 9. After you have taken the Motor out of the printer, remove the pulley using a 1/16" hex key
Reinstalling
STEP 1. Install the pulley and flywheel onto the new motor. The flywheel should be installed approxi-
STEP 2. Insert the motor through the Power Supply opening and reinstall the mounting screws loosely.
STEP 3. Reinstall the drive belts onto the pulley.
STEP 4. Apply slight downward pressure on the motor to remove slack in the drive belts, then tighten
STEP 5. Reconnect the paper motor cable to the extension cable coupling just inside the Power Supply
STEP 6. Reinstall the Power Supply and plug it in to the Engine Controller CBA.
STEP 7. Phase the Upper and Lower tractors using Phasing Gauge (#075467) from tool kit (#081147).
STEP 8. Adjust the Paper Motor Belts for proper tension using Paper Belt tension gauge (#081148) in
STEP 9. Reinstall the Left End Cover.
STEP 10. Reinstall the Right End Cover and Control Panel.
STEP. 11. Reinstall the Sound Deadening Hood and Paper Tray.
4–36
wrench, and motor flywheel using a 5/64 hex key wrench.
Flywheel
Paper Drive
Pulley
mately .10" from the Motor body, and the pulley should be flush against the flywheel.
the mounting screws.
opening.
(Refer to Procedure 21)
tool kit (#081147). (Refer to Procedure 21.)
Optional: Before continuing with motor installation, you may want to plug in the control
panel and perform a motor test with the FORM FEED Key, LINE FEED Key, and the
Key. Make sure you enable the fault overrides before attempting these tests.
Figure 4–32. Paper Advance Motor Assembly
Paper Advance
Motor
Flywheel
Set Screws, 2x