Table of Contents
Advertisement
Platen Parameter (Menu Level 2)
This parameter provides fault override for the Platen Open Sensor.
Ctrl (Control Processor) Parameter (Menu Level 2)
This parameter provides fault override for the control processor fault reporting status.
Link Parameter (Menu Level 2)
This parameter provides fault override for control processor to main processor communica-
tions.
Hvy Frm (Heavy Forms) Parameter (Menu Level 2)
This parameter overrides automatic platen gap sensing.
Panel Parameter (Menu Level 2)
This parameter provides fault override for Panel Fault reporting.
Control Panel Key Operations For Controlling Fault Reporting
In addition to being able to use the above parameters to set up individual fault overrides, you
may also use three different key sequences to set up fault overrides. You may set up all fault
overrides, four specific overrides, or just Paper Out Fault override.
To use the following options the printer must be in Tech Access Mode.
ALL Fault Reporting
To turn ALL fault reporting OFF, place the printer Offline and depress the FORM FEED Key
and ENTER Key simultaneously until the printer alarm sounds. To turn ALL fault reporting
back ON, hold down the same two keys when the printer is Offline until the printer alarm
sounds.
Four Faults Only
To turn fault reporting OFF for Paper Motion, Paper Out, Ribbon Fault, and Platen Open
sensors, hold down the ENTER Key and TOF Key simultaneously until the printer alarm
sounds. To toggle them back ON, hold down the same two keys until the printer alarm sounds.
Paper Out Only
To turn OFF fault reporting for the Paper Out sensor, depress the FORMS/1 Key and EN-
TER Key simultaneously until the printer alarm sounds. To turn it back ON, depress the same
keys until the printer alarm sounds.
The displays that appear when you are enabling the options above can be somewhat
confusing. Just remember, when you turn on fault overrides you are losing fault
protection.
Chapter 2: Menu Operations
2–13
Advertisement
Table of Contents
Troubleshooting
