Figure 4–39. Lower Tractor Alignment - Tally T6090 Maintenace Manual

T6090 Maintenance Manual
STEP 5. Remove the nut on right end of support shaft. Slide the support shaft to the left far enough to
Reinstalling
4–42
take off the second nut on the support shaft. You now have enough room to slide off both
tractors by sliding them to the right. Keep track of springs and washers on thesupport shaft
when removing.
When removing the lower tractors, you must unplug the paper out sensor cable (J602)
from the Engine Controller CBA, two cable support, and a ferrite bead encircling the
cables. (The Paper Out Sensor is attached to the lower right tractor).
Reinstallation of the lower tractors is the reverse sequence of removal.
When installing the lower tractors, be sure that the alignment mark on the inner face of
each tractor is positioned the same as the opposite tractor.
"C" Clip
Left Tractor
Alignment
Mark
Figure 4–39. Lower Tractor Alignment
Alignment
Mark
Right Tractor
Support
Shaft Nut