Procedure 24 - Lower Tractor Assembly - Tally T6090 Maintenace Manual

Procedure 24 – Lower Tractor Assembly
Removing
STEP 1. Remove Right End Cover (see Procedure 3).
STEP 2. Remove Left End Cover (see Procedure 8).
STEP 3. Remove the snap rings from both ends of the square shaft using the snap ring removal tool in
STEP 4. Slide the square drive shaft to the left through upper tractor pulley. Do not remove the pulley
Tractor Drive
Shaft Pulley
Drive Shaft
Before beginning this procedure, turn the printer off and disconnect the power cable.
tool kit (#081147). Leave the snap rings so they are sitting loosely on the shaft.
or drive belt from the shaft.
If the pulley or drive belt are removed from the printer, you will need to rephase the
upper and lower tractor sets.
Figure 4–38. Removing Lower Tractor Assembly
Chapter 4: Removal and Reinstallation Procedures
Snap Ring
Drive Belt
Pulley
Support
Shaft
Snap Ring
Support
Shaft Nuts, 2x
4 –41