Figure 4–12. Removing The Power Supply - Tally T6090 Maintenace Manual

T6090 Maintenance Manual
STEP 2. Remove Right End Cover (see Procedure 3) and disconnect the Power Supply from the Engine
STEP 3. Remove the five screws securing the Power Supply to the printer. You can now remove the
Reinstalling
4–14
Controller CBA (J302 ) and remove the cable from the cable supports (2 ea) that route the
cable to the Engine Controller CBA.
Power Supply from the Printer.
To install the Power Supply, reverse the sequence of the above steps.
Figure 4–12. Removing the Power Supply