Procedure 10 - The Ribbon Motor - Tally T6090 Maintenace Manual

T6090 Maintenance Manual
Procedure 10 – The Ribbon Motor
Removing
STEP 1. Remove the Ribbon Platform (see Procedure 9).
STEP 2. Remove the panduit that secures the Ribbon Motor cable to the platform. The motor can now
STEP 3. Remove the four screws that secure the motor to the Ribbon Platform.
Reinstalling
STEP 1. Insert the motor shaft through the hole in the Ribbon Platform, then align the screw holes
STEP 2. Reinstall the Ribbon Platform.
4–18
Before beginning this procedure, turn the printer off and disconnect the power cable.
be removed.
(make sure that the motor cable is on the side toward the Control Panel) and reinstall the motor
mounting screws. Secure the Ribbon Motor cable to the platform with a panduit.
Figure 4–16. Removing the Ribbon Motor
Ribbon Motor
J502