Max T (Maximum Temperature) Parameter (Menu Level 2); Enstar (Energy Star) Parameter (Menu Level 2); Energy Star Selections (Menu Level 3); Clear Parameter (Menu Level 2) - Tally T6090 Maintenace Manual

T6090 Maintenance Manual

Max T (Maximum Temperature) Parameter (Menu Level 2)

EnStar (Energy Star) Parameter (Menu Level 2)

Energy Star selections (Menu Level 3)

Clear Parameter (Menu Level 2)

Clear selections (Menu Level 3)

Fault Override (FltOvrd) Category (Menu Level 1)

Pap Mot (Paper Motion) Parameter (Menu Level 2)

Pap Out (Paper Out) Parameter (Menu Level 2)

Rib Mot (Ribbon Motion) Parameter (Menu Level 2)

Shuttle Parameter (Menu Level 2)

Temp (Temperature) Parameter (Menu Level 2)

2–12
Max T is the thermal limit for the printer. If the thermistor on the Engine Controller PCB
exceeds this limit, the Thermal Fault message will appear on the Control Panel Display.
DO NOT change the factory setting.
This parameter allows you to control Energy Star Operation on the printer.
OFF
ON
This parameter provides you with a means of clearing part or all of NVRAM.
CalData Clears the calibration data from NVRAM. When CalData is selected you will
have to perform a Hammer Calibration Routine before using the printer.
Counts Clears the count information from NVRAM.
NVRAM Clears ALL NVRAM.
This category provides you a means of controlling fault reporting from the Engine Manager to
the Control Processor. Each of the following parameters has two selections: OFF and ON.
When the parameter is set to OFF, faults are reported as they happen (Fault Override is dis-
abled). When the parameter is set to ON, faults are not reported on the display (Fault Override
is Enabled).
This parameter provides fault override for Paper Motion Faults.
This parameter provides fault override for Paper Out Faults.
This parameter provides fault override for Ribbon Motion Faults.
This parameter provides fault override for Shuttle Fault reporting.
The Temp Parameter provides fault override for Temperature Threshold fault reporting.