Procedure 13 - Hammer Bank Air Duct - Tally T6090 Maintenace Manual

Procedure 13 – Hammer Bank Air Duct
Removal
STEP 1. Remove the Hammer Bank (see Procedure 11).
STEP 2
STEP 3. Remove the six screws that attach the airduct to the Hammer Bank. You now can remove the
Air Duct Mounting
Screws, 6x
Reinstallation
Before beginning this procedure, turn the printer off and disconnect the power cable.
Remove the cable clamp bracket and screw.
airduct from the Hammer Bank.
Hammer Bank
Air Duct
Figure 4–20. Removing Hammer Bank Air Duct
To reinstall, reverse the sequence of removal.
Chapter 4: Removal and Reinstallation Procedures
Cable Clamp
Cable Clamp
Screw
4 –23