Update* Signal; Figure 4-21. Wftrig Input Signal Timing; Figure 4-22. Wftrig Output Signal Timing - National Instruments PCI-6110E/6111E User Manual

© National Instruments Corporation
Figures 4-21 and 4-22 show the input and output timing requirements
for the WFTRIG signal.
Rising-edge
polarity
Falling-edge
polarity

Figure 4-21. WFTRIG Input Signal Timing

Figure 4-22. WFTRIG Output Signal Timing

UPDATE* Signal

Any PFI pin can externally input the UPDATE* signal, which is
available as an output on the PFI5/UPDATE* pin.
As an input, the UPDATE* signal is configured in the edge-detection
mode. You can select any PFI pin as the source for UPDATE* and
configure the polarity selection for either rising or falling edge. The
selected edge of the UPDATE* signal updates the outputs of the DACs.
In order to use UPDATE*, you must set the DACs to posted-update
mode.
As an output, the UPDATE* signal reflects the actual update pulse that
is connected to the DACs. This is true even if the updates are being
externally generated by another PFI. The output is an active low pulse
with a pulse width of 50 to 75 ns. This output is set to tri-state at startup.
t
w
t
= 10 ns minimum
w
t
w
t
= 25-50 ns
w
4-27
Chapter 4 Signal Connections
PCI-6110E/6111E User Manual