Table of Contents
Advertisement
Installation and
Configuration
Software Installation
Hardware Installation
© National Instruments Corporation
This chapter explains how to install and configure your 611X E board.
Install your software before you install the 611X E board. Refer to the
appropriate release notes indicated below for specific instructions on
the software installation sequence.
If you are using LabVIEW, LabWindows/CVI, or other National
Instruments application software packages, refer to the appropriate
release notes. After you have installed your application software, refer
to your NI-DAQ release notes and follow the instructions given there
for your operating system and application software package.
If you are using NI-DAQ, refer to your NI-DAQ release notes. Find
the installation section for your operating system and follow the
instructions given there.
You can install the 611X E board in any available expansion slot in your
computer. However, to achieve best noise performance, leave as much
room as possible between the 611X E board and other boards and
hardware. The following are general installation instructions, but
consult your computer user manual or technical reference manual for
specific instructions and warnings.
1. Write down the 611X E board serial number in the
PCI-6110E/6111E Hardware and Software Configuration Form
Appendix D, Customer Communication,
2. Turn off and unplug your computer.
3. Remove the top cover or access port to the I/O channel.
4. Remove the expansion slot cover on the back panel of the
computer.
2-1
Chapter
2
of this manual.
PCI-6110E/6111E User Manual
in
Advertisement
Table of Contents
