Table of Contents
Advertisement
Section 700 - Operation
To clear the ID Code:
1. Go offhook or press ON/OFF key.
2. Dial the Call Forward ID Code (default = 715 [UK/HK or
715# [Taiwan, Malaysia, Indonesia]).
3. Press the HOLD key.
4. Go onhook or press ON/OFF key.
Hardware Requirements
•
N/A
Considerations
•
N/A
CLI/DDI Voice Mail ID Code
CLI/DDI calls may be sent directly to voice mail through the used of the DDI Voice Mail ID Code. A
prefix and suffix may be specified to be sent to the voice mail as well as a chosen number of DDI
digits.
Either no digits (default), the last two digits of the DDI, the last three digits of the DDI or the entire
DDI number may be sent.
The prefix may be up to eight digits including 0-9, *, # and pause (REDIAL).
The suffix may be up to eight digits including 0-9, *, # and pause (REDIAL).
Hardware Requirements
•
N/A
Considerations
•
Each pause is a fixed 1 second delay.
•
If you do not assign a Voice Mail ID Code, the DDI digits will be sent to voice mail.
•
Only one Voice Mail ID Code is available for the system.
Disconnect Signal
Beginning with CPC Version 3.0, either busy tone or silence can be sent to a third-party voice mail
system when the caller hangs up.
High Priority Message Waiting
Message waiting displays and LEDs may be utilized by the Voice Mail system to indicate that a Voice
Mail message has been left in your mail box. When you retrieve the message, the message waiting
indications are cleared.
Hardware Requirements
•
N/A
ICX-35-700
Action
ICX (International), issued March/1998
Chapter 3. System Features
Result
Enter V.M. ID displays
Cleared V.M. ID displays
69
Advertisement
Table of Contents
