Table of Contents
Advertisement
Section 700 - Operation
Hardware Requirements
•
N/A
Considerations
•
Calling parties without a display get a busy signal, rather than the Absence Message.
•
Regardless of setting an Absence Message on a DDI/DIL extension, DDI/DILcalls are routed
according to the trunk ringing setting.
•
An absence message may also be cancelled by dialing 7**. This cancels Do Not Disturb (DND)
and Call Forwarding-All Calls as well.
Account Codes
CPC-96, CPC-288, and CPC-576 All Versions
Description
You can assign account codes to clients to facilitate billing and to track call dates and times, numbers
called, and outside line numbers used. This information is printed for each account on the System
Message Detail Recording (SMDR) (Call Logging) record.
In addition verified account codes may be used to change the Toll Restriction Service (TRS) (Call
Barring) level to allow calls to numbers otherwise restricted.
Account codes may be either forced or unforced (voluntary) and either verified or unverified.
This feature works with SMDR (Call Logging). During a phone call, a station user can silently enter
an accounting or client billing code. The entered Code will display on the phone's LCD as it's dialled,
so the user can tell it's being registered. Then later, the Call Logging reports will show the Code
dialled for each call, and even sort the report by these Codes.
There are two different types of account codes you can use in the ICX:
Non-Verified Account Codes
Non-Verified Codes aren't checked by the system for validity; the user can enter anything from 1-10
digits long. Individual phones can be programmed to accept forced Account Codes (the user must
enter a code for every call) or voluntary Account Codes (the user can enter a code, but doesn't have
to, for each call).
Non-Verified Account Codes can be assigned to incoming and/or outgoing calls. For incoming calls,
the user can enter the Code anytime during the call. For outgoing calls, the user either enters the Code
before accessing an outside line (for forced Codes), or anytime during the call (for voluntary Codes).
Verified Account Codes
Verified Account Codes entered by phone users must match a 4-digit code that has been
preprogrammed into an Account Code Table. (It is possible to enter up to 10 digits for a Verified
Account Code; however, only the first 4 digits will be used to verify the code.) These codes can also
be either forced or voluntary. You can program these codes with their own Toll Restriction Service
(TRS) - Call Barring Class assignment so that, when entered, they will override the extension's TRS
(Call Barring) Class. Thus, Verified Account Code users can "float" from phone to phone, placing
calls that would normally be restricted on that phone.
ICX-35-700
ICX (International), issued March/1999
Chapter 6. DSLT Features
211
Advertisement
Table of Contents
