Table of Contents
Advertisement
Chapter 6. DSLT Features
To set Manual Camp-on:
1. Lift the handset or press the ON/OFF key.
2. Dial the extension number.
3. Enter the Camp-on (Call Waiting) code (default = 2 [UK/
HK] or 2# [Taiwan, Malaysia, Indonesia]).
4. Remain on the line until the called party answers.
To answer a Camp-on (Call Waiting) signal:
1. Replace the handset or press the ON/OFF key.
2. Lift the handset or press the ON/OFF key again to be con-
nected to the waiting call.
OR....
Press the HOLD key.
Hardware Requirements
•
N/A
Considerations
•
You can transfer an outside call to a busy extension using Camp-on. See "Camping a Call Onto a
Busy Extension" on page 230.
Conference Calls
CPC-96, CPC-288, and CPC-576 Version 3.0
Description
Conference Calls allow you to add another party to an existing conversation. With the standard
system configuration, up to 3 parties can be included in a conference call at any one time. If the
optional Conference Card is installed, additional parties up to a total of 8 can participate in a
conference call.
The CPC Version 3.0 software release allows any combination of extensions and trunk lines be in the
conference as long as the original extension is in the conference and the total number of parties does
not exceed 8. With CPC Version 3.0 software, only one operation is used to establish and add to a
conference. You simply have to place the current call on hold, dial the next party and press the CONF
key. No different operation or access code is required to add additional parties to the call.
When no optional conference card is installed, the system supports the following types of three-party
conference calls:
•
3 extensions
232
Action
Action
ICX (International), issued March/1999
Section 700 - Operation
Result
Intercom dial tone
Busy tone
• Called party hears alert tone
• Calling party hears ringback tone
Result
• Current call placed on hold
• Connected to waiting call
ICX-35-700
Advertisement
Table of Contents
