Adjustment
13
Adjustment of the sewing head
.06
13
Adjusting the synchronizer
.06.01
13 - 4
Requirement
Upon completion of the sewing operation, the sewing machine should be positioned in
the TDC of the needle bar.
2
Fig. 13 - 03
Switch on the machine.
Slide the feed carriage to zero point by hand (see Chapter 8.04 Checking /setting zero
point).
Press the home position key on the control panel.
Loosen screw 1.
Hold synchronizer 2 firmly while turning the handwheel to position the needle bar at
TDC.
Tighten screw 1.
Perform a check according to the requirement.
1