Table of Contents
Advertisement
7- CARRIAGE START (NIS = needle in material)
Needle leaves
the material,
carriage start
approx. at 270°
Needle in material,
Fig. 11 - 01
The command for the carriage start is output when the needle pierces the material.
However, the carriage actually starts when the needle leaves the material (constant 180°
later). The point in time for the output of the carriage start command can be changed in
the range of 0 - 360°.
Under certain conditions, the stitch formation can be influenced by the setting.
To avoid thread disturbances, the value should be between 60° and 120°.
5- SWITCH FUNCTIONS
Under this main function, the user can program machine functions according to his
requirements in the subfunctions.
1- THREAD MONITOR FUNCTIONS
Thread monitor functions are listed here which can be turned on or off via the
number keys 1 or 0.
1- THREAD MONITOR
2- BOBBIN MONITOR
3- BOBBIN SENSOR (option)
2- SEWING HEAD FUNCTIONS
Sewing head functions are listed here which can be turned on or off via the
number keys 1 or 0.
1- NEEDLE COOLING
2- THREAD PULLER
Increases the thread amount when starting to sew.
3- THREAD WIPER
Needle
at TDC
continuous area
of 180°
Programming
Needle pierces material,
carriage stops,
command for carriage
start is output
approx. at 90°
11 - 6
Advertisement
Table of Contents
