Table of Contents
Advertisement
OBSTACLES : YES " + " , NO " - "
The selection depends on the clamp type.
CLAMP WITHOUT OBSTACLE
Following input of the above functions switch to INSERT mode. The diode in the key is lit.
Ins
Activate straight line function.
INSERT STRAIGHT LINE
Move to loading position.
(For clamps without obstacles with one straight line, otherwise the obstacles must be
circumvented with several straight lines).
000
000
ENTER END POINT OF STRAIGHT LINE
The coordinates for the loading position are shown in the display.
Press Enter key.
Enter
END POINT OF STRAIGHT LINE
Turn off straight line function (diode off).
F2
Activate machine function menu function (diode lit).
SPEED :
or
Press plus or minus key until the CLAMP function appears in the display.
CLAMP 1
Enter
Press Enter key.
3 : OBSTACLES
3 : OBSTACLES
3 : OBSTACLES
5 : STITCH LENGTH
6 : STRAIGHT LINE
6 : STRAIGHT LINE
6 : STRAIGHT LINE
00 RPM
6 : STRAIGHT LINE
Programming
11 - 14
Advertisement
Table of Contents
