Table of Contents
Advertisement
What you see on the
LCD
Please Supply Paper
Please Wait
Polling In Use
Printer In Use
Protect Doc. Stored
Remove Tray Paper
Open & Close Top Cover
Scanner In Use
Stop Scanning
ContStor Enter/Cancl
Sub-address In Use
Toner Low
What it means/What to do
The paper cassette or multiple paper feeder tray
is out of paper. Add paper to the cassette and/or
the tray.
Your fax machine's printer is either warming up
or busy. Please wait until the fax is finished
printing and then re-try your command or opera-
tion.
You tried to store the polling document in your
fax machine, where one already had been
stored. Wait for the fax to complete the regular
polling operation, then try again.
The command you're trying to enter requires the
use of the printer, which is already in use. Wait
for the fax to finish printing, then try again.
A received document was in your fax's memory
when you tried to turn off the security reception
passcode. Print the received document from your
fax's memory, then retry the desired operation.
Your fax machine has detected a paper jam in
the multi paper tray. See page 3.3 for instruc-
tions on clearing the jam.
The command you're trying to enter requires the
use of the scanner, which is already in use. Wait
for the fax to complete the scan, then re-try the
desired command.
You opened the top cover while the machine
was scanning the document (for either faxing or
copying) using the
. To continue the scan,
FBS
press
. To abort the scan, press
ENTER
You tried to enter a sub-address identical to one
already being used in another F-Code box. Enter
a different sub-address.
Your fax machine is almost out of toner.
Contact your authorized Muratec dealer to pur-
chase a new toner cartridge if you don't already
have one.
What you see on the
Too Many Characters
Too Many Locations
Too Many Steps
1 Location or Less
Errors
When sending faxes, your machine occasionally runs into communications errors.
These can be caused by anything from lightning to telephone line interference.
(These same factors cause the static, or line noise, you sometimes hear on phone
calls.) They also can be caused by problems with the fax machine at the other end of
the line.
Often, simply trying your call again is all that's necessary. However, if the problem
.
CANCEL
persists regularly, call your local telephone company for help. If that doesn't help and
the problem persists regularly, call your authorized Muratec dealer.
Error reports
When an error occurs, your fax machine prints an error report. Each fax error report
lists an error message which includes:
• A possible solution to the problem
• The sending location (if the remote fax stores a Location
• The result — which is a special error code.
• A sample of the document's first page.
What it means/What to do
LCD
You attempted to enter too many numbers or
other characters in the current operation.
Press
to delete the extra characters, then
CANCEL
try again. You may wish to review the operation's
appropriate instructions.
You tried to enter too many numbers for a
broadcast. You can enter up to 10 one-touch or
speed-dial numbers and numbers entered
through the numeric keypad.
Press
to delete the extra numbers and
CANCEL
then try again.
You tried to enter too many steps for a macro.
You can enter up to 60 steps into a macro key.
You tried to enter too many forwarding numbers
for fax forwarding through the numeric keypad.
You can enter up to 201 forwarding numbers by
using one-touch key, speed dial number, group
number and numeric keypad, but you can enter
only 1 location by using numeric keypad (see
page 2.36).
Just in case ...
of its own)
ID
3.9
Advertisement
Table of Contents
