Suzuki GSX-R1000 Service Manual page 597

Hide thumbs Also See for GSX-R1000:
Table of Contents

Advertisement

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
2
"B"
1
"A"
16
1. Clamp
: Pass the side-stand switch lead wire left side of the water by-
pass hose and clamp them in this range. Cut off the excess tip
of the clamp.
2. Clamp
: Bind the lead wires at the blue taping point and face the clamp
end to the engine side.
3. IAT sensor
4. ISC valve
5. Clamp
: Bind the lead wires with throttle body at blue taping point and
face the clamp end forward.
6. White coupler (for ignition coil #1)
7. Clamp:
Face the clamp end upward.
8. STVA lead wire
9. Wiring harness
10. ISC valve lead wire
11. Regulator/rectifier lead wire
12. EVAP system purge control solenoid valve lead wire (E-33 only)
email: info@motomatrix.co.uk / www.motomatrix.co.uk
13
17
6
15
14
13. Battery negative lead wire
14. Rear brake light switch lead wire
15. Crankcase breather (PCV) hose
16. Starter motor lead wire
17. CKP sensor lead wire
"A": Pass the side-stand switch lead wire between the water hoses.
"B": Plate the joint coupler to the engine side and pass the side-stand switch lead
"C": Pass the rear brake light switch lead wire between the frame and drain hose,
"D": Pass the CMP sensor lead wire between ignition coil #1 and #2.
"E": Pass the wiring harness above the air cleaner duct.
"a": 60 ± 5°
5
3
4
"D"
"E"
" a "
7
11
: Pass the battery negative lead wire in front of the PCV hose. (For E-33, pass
the lead wire below the EVAP solenoid hoses, and between the EVAP solenoid
lead wire and wiring harness.)
: Pass the rear brake light switch lead wire below the wiring harness and battery
negative lead wire at the frame bridge part, then above the wiring harness at
the fuel tank rail part. (For E-33, pass the brake light switch lead wire between
EVAP solenoid bracket and frame.)
: Route the CKP sensor lead wire in front of the PCV hose and above the
battery negative lead wire.
wire and speed sensor lead wire left side of the water by-pass hose.
and under the clamp.
Wiring Systems:
9A-8
"C"
Upside
8
9
10
13
14
12
9
I947H1910908-03

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents