Fuel Line Inspection; Evaporative Emission Control System Inspection (E-33 Only); Engine Oil And Filter Replacement; Engine Oil Replacement - Suzuki GSX-R1000 Service Manual

Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys

Fuel Line Inspection

Inspect fuel line
Every 6 000 km (4 000 miles, 12 months)
Inspect the fuel line in the following procedures:
1) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation" in Section 1G (Page 1G-
9).
2) Inspect the fuel feed hose (1) for damage and fuel
leakage. If any defects are found, the fuel feed hose
must be replaced.
WARNING
!
When disconnecting the fuel feed hose from
E-33 model, drain fuel from the fuel tank first
to prevent fuel leakage.
3) After finishing the fuel feed hose inspection, reinstall
the removed parts.
Evaporative Emission Control System
Inspection (E-33 only)
Inspect evaporative emission control system
Every 12 000 km (7 500 miles, 24 months)
Inspect the evaporative emission control system
periodically (E-33 only). Refer to "Evaporative Emission
Control System Inspection (Only for E-33)" in Section 1B
(Page 1B-14).

Engine Oil and Filter Replacement

Replace engine oil
Initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter
Replace oil filter
Initially at 1 000 km (600 miles, 2 months) and every
18 000 km (11 000 miles, 36 months) thereafter
Oil should be changed while the engine is warm. Oil filter
replacement at the above intervals, should be done
together with the engine oil change.
email: info@motomatrix.co.uk / www.motomatrix.co.uk

Engine Oil Replacement

B947H10206008
1
I947H1020008-01
B947H10206009
B947H10206010
Maintenance and Lubrication:
1) Place the motorcycle on the side-stand.
2) Place an oil pan below the engine, and drain engine
oil by removing the oil drain plug (1) and filler cap
(2).
1
3) Tighten the oil drain plug (1) to the specified torque.
CAUTION
!
Replace the gasket washer with a new one.
Tightening torque
Oil drain plug (a): 23 N·m (2.3 kgf-m, 16.5 lbf-ft)
4) Pour new oil through the oil filler. When performing
an oil change (without oil filter replacement), the
engine will hold about 2.8 L (3.0/2.5 US/lmp qt) of oil.
Use of SF/SG or SH/SJ in API with MA in JASO.
5) Start up the engine and allow it to run for several
minutes at idling speed.
6) Turn off the engine and wait about three minutes.
0B-10
I947H1020009-01
2
I947H1020010-01
1
(a)
I947H1020011-01