Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
Steering Damper Construction
1. Steering damper
2. Dust seal
Steering / Steering Damper Removal and
Installation
Removal
Steering damper
1) Turn the ignition switch OFF.
2) Disconnect the steering damper solenoid coupler
(1).
1
3) Remove the lower bracket cover (2).
4) Remove the steering damper mounting nut (3) while
holding the lock-nut (4).
email: info@motomatrix.co.uk / www.motomatrix.co.uk
1
3
3. Bearing
B947H16206006
I947H1620018-01
2
I947H1620019-01
2
2
(a)
I837H1620040-01
: 23 N⋅m (2.3 kgf-m, 16.5 lbf-ft)
5) Remove the steering damper mounting bolt (5).
6) Remove the steering damper (6).
Steering
1) Support the motorcycle with a jack or wooden block.
CAUTION
!
Do not work by using side stand. Do not
support the motorcycle with exhaust pipe.
Make sure that the motorcycle is supported
securely.
2) Remove the front wheel assembly. Refer to "Front
Wheel Assembly Removal and Installation" in
Section 2D (Page 2D-4).
3) Remove the front forks. Refer to "Front Fork
Removal and Installation" in Section 2B (Page 2B-2).
4) Remove the steering damper. Refer to "Steering /
Steering Damper Removal and Installation"
(Page 6B-6).
5) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation" in Section 1G (Page 1G-
9).
Steering / Handlebar:
B947H16206005
: Apply grease.
6
4
5
3
I947H1620020-01
6B-6