ENGINE MAIN PARTS
Front identification
mark (on the valve
side) ø3 [0.12 in.]
hole 1 mm [0.04 in.]
deep
Figure 31
Installing rocker shaft and rocker cover
Figure 32
Inspecting rocker shaft and rocker arms
Service Manual Mitsubishi L-Series diesel engines
Version 08/2004
Rocker cover nut tightening
torque: 4.9 to 6.9 N·m (0.5 to
0.7 kgf·m) [3.62 to 5.06 lbf·ft]
Stay tightening torque:
14.7 to 21.6N·m
(1.5 to 2.2 kgf·m)
[10.85 to 15.91 lbf·ft]
ROCKER ARMS AND ROCKER SHAFT
8.2
Removal and installation
CAUTION
a.
Be careful not to confuse proper direction of
installation of the rocker shaft.
b.
After installing the rocker shaft, adjust valve
clearance.
8.3
Inspection
Check the rocker shaft and rocker arms. If any
defective parts are found, replace them.
ENGLISH
43 / 155