Rrp 63 Auxiliary Feeder Paper Feed Motor Assembly - Xerox Phaser 7700 Service Manual

RRP 63 Auxiliary Feeder Paper Feed Motor
Assembly
Paper Feed
Motor Assembly
Trays 2 & 3 - HCF
Trays 2, 3, & 4 - LTA
Chute to Lower
Figure 7-66 Paper Feed Motor Assembly and Chute (LTA & HCF)
Removal
1. Remove the Left-Hand Cover.
2. Open the Tray halfway.
3. Disconnect the wiring harness.
4. Remove the two screws holding the Tray 1 feeder assembly, not the screws
securing the lower tray bracket.
5. Remove the Tray feeder assembly.
Note Some wiggling may be required to disengage the gears.
Removal of Motor
1.
Disconnect the wiring harness from the motor.
2.
Remove the two screws securing the motor to the feeder bracket.
3.
Lift the motor straight out of the bracket to clear the gear on the motor shaft.
Note
When reinstalling the motor, it may be necessary to manually
rotate the gears to mesh them with the other gears.
Service Quick Reference Guide - Removal & Replacement Procedures
LEFT SIDE
S7700-102
,
7-213