RRP 52 Developer Drive Assembly
Figure 7-55 Developer Drive Assembly
Removal
1.
Remove the 3.3 VDC and 5 VDC Power Supply and bracket assembly (RRP 45,
on page 7-194).
2.
Disconnect the wiring harness from the Developer Drive Assembly.
3.
Clear the high-voltage lines.
4.
Remove the two black screws securing the Developer Drive Assembly to the
printer frame and remove from the printer.
Note
When reinstalling, rotate the main drive to ensure the gears move
freely.
Service Quick Reference Guide - Removal & Replacement Procedures
S7700-008
7-201