Shutter Solenoid Assembly; Figure 7-22 Shutter Solenoid Assembly; Rrp 21 Shutter Solenoid Assembly - Xerox Phaser 7700 Service Manual

RRP 21 Shutter Solenoid Assembly

Figure 7-22 Shutter Solenoid Assembly

Removal
1. Partially remove the MPT (RRP 12, on page 7-152).
2. Partially remove the Left-Hand Cover Assembly (Left Door) (RRP 14, on page
7-154).
3. Remove the Registration Transport Assembly (RRP 20, on page 7-161).
Note Note the wiring.
4. For easier access remove the Duplex Chute (RRP 15, on page 7-156).
5. Disconnect the wiring harness from the front frame connector.
6. Note the locating pin, then loosen the one screw that secures the assembly to
the frame and remove the shutter solenoid assembly.
Replacement
Caution
It is very easy to miss positioning the lever back into the slot upon
re-assembly.
1.
Remove the Waste Toner Cartridge.
2.
Remove the black Print Cartridge.
3.
While reinstalling the shutter solenoid assembly, with a flashlight, view where
the Solenoid Lever engages the notch in the shutter plate.
4.
Tighten the mounting screw and reconnect the wiring harness.
7-162 Phaser 7700 Color Laser Printer