Xerox Phaser 7700 Service Manual page 4

Fuser Components:
WARNING: This printer uses heat to fuse the toner image to a sheet of paper. The
Fuser Assembly is very hot. Switch off printer power and wait at
least 30 minutes for the Fuser to cool before you attempt to service
the Fuser Assembly or adjacent components.
Safety Components: Make sure covers and panel are in place and that all interlock
switches are all functioning correctly after you have completed a printer service
call. If you bypass, or cheat, an interlock switch during a service call, use extreme
caution when working on or around the printer.
Warning Labels: Throughout the printer, warning labels are displayed on
potentially dangerous components. When you service the printer, check to make
certain that all warning labels are in place.
Most importantly, read and obey all posted warning labels.
WARNING: Turning the power off using the On/Off switch does not de-energize
the printer. You must remove the power cord to disconnect the
printer from the main power source. Keep the power cord accessible
for removal in case of an emergency.
Safety instructions: Read all installation instructions carefully before you plug the
product into a power source.
Care of product: Disconnect the power plug by pulling the plug, not the cord.
Disconnect the power plug if the power cord or plug is frayed or otherwise
damaged,
Or if any liquid or foreign material is spilled into the case,
Or if the printer is exposed to any excess moisture,
Or if the printer is dropped or damaged,
Or if you suspect that the product needs servicing or repair,
And whenever you clean the product.
Ground the product: Plug the three-wire power cord (with grounding prong) into
grounded AC outlets only. If necessary, contact a licensed electrician to install a
properly grounded outlet.