Multi-Purpose Tray (Mpt) Assembly; Figure 7-12 Mpt Assembly; Rrp 12 Multi-Purpose Tray (Mpt) Assembly - Xerox Phaser 7700 Service Manual

RRP 12 Multi-Purpose Tray (MPT) Assembly

Figure 7-12 MPT Assembly

Removal
Note Complete MPT removal is not necessary when doing jobs such as
shutter solenoid or main motor assembly replacement. Remove the
two MPT screws (step 5 below), and let the MPT hang by the wire
harness for partial removal.
1.
Remove the Top, Mid and Rear Covers (RRP 5, on page 7-144).
Note Note the routing of the MPT Assembly wiring harness. The
wiring harness feeds through the access hole at the pivot point and
up to the connector. When assembling, be sure the wire harness is
behind the mounting tab.
2. Release the wiring harness clip from the printer's frame.
3. Pull the MPT Assembly wiring harness through the access hole.
4. Close the Left-Hand Cover Assembly (Left Door).
5. Remove the two screws that secure the MPT Assembly then pull the assembly
out of the printer. A slight lift on the right-hand side of the MPT Assembly may
help remove it from the printer.
Caution
The Duplex Chute (RRP 15, on page 7-156) must be in the up
position to install the MPT. Raise the Duplex Chute by reaching
into the MPT installation hole.
Caution When reinstalling the MPT, make certain you DO NOT pinch the
wire between the left bracket and the left screw hole.
7-152 Phaser 7700 Color Laser Printer