Xerox Phaser 7700 Service Manual page 60

Table 3-2 Service Diagnostics Test Menu Functions (cont'd.)
Test Front Panel Display
Built-In Test Prints
Prints pre-defined images stored in the engine firmware for troubleshooting image
quality problems.
Paper Path For Print Laser Check only: Selects tray, count of/continuous sheets,
Options simplex/duplex, offset, media type/weight, finisher, staple.
Source tray: Tray 1-4, MPT
Yes
No
Current # sheets is n
Select new # sheets?
Yes
No
Simplex/Duplex:
Change Duplex setting?
Yes
No
Offset: None, Auto, Front, Rear
Set a new offset?
Yes
No
Media Type:
Set New Media Type?
Yes
No
Output Destination
Change Output Setting?
Yes
No
Stapling is:
Set new stapling options?
Yes
No
Print Laser Fuser warming up
Check Laser Init
Startup | Imaging | Delivering |
Finishing
Laser Done
Print Halftones HalfTones Init
Startup | Imaging | Delivering |
Finishing
HalfTones Done
Print Grid 1-dot Grid Init
Startup | Imaging | Delivering |
Finishing
Grid Done
Service Quick Reference Guide - Diagnostics, Error Codes & Messages
Test Operation, Results and
Function
Definition
Press Up/Down to change setting.
1. Press Up/Down to change the
number.
2. Press Info to shift column.
Press Up/Down to change setting.
Press Up/Down to change setting.
Press Up/Down to change setting.
Press Up/Down to change setting.
Note
This option is only available
with an optional finisher
installed.
Press Up/Down to change setting
Note
This option is only available
with an optional finisher
installed.
This is a quick test for all four laser
colors, including developer and toner.
All four primaries are present on the
page. The print should appear grey.
Prints 6 pages of 100% solid fill for;
Yellow, Magenta, Cyan, Black, Red
and Green.
This print displays the four primary
color lines in a grid pattern.
Registration Control Procedures on
page 4-117
2-37