Figure 7-34 Mark-On-Belt Sensor; Rrp 32 Mark-On-Belt (Mob) Sensor - Xerox Phaser 7700 Service Manual

RRP 32 Mark-On-Belt (MOB) Sensor

Figure 7-34 Mark-On-Belt Sensor

Removal
1.
Remove the Waste Cartridge Assembly (RRP 23, on page 7-164).
2.
Remove the Waste Toner Agitator Motor (RRP 31, on page 7-176).
3.
Remove left-hand inner cover.
4.
Disconnect the purple harness.
5.
Remove the wiring harness from three clips.
6.
Remove the one black screw and remove the Mark-On-Belt assembly
Note
If the Mark-On-Belt adjustment procedure (RegiCon DC685-3) is
being performed, then proceed to the following steps.
Reverse these steps to install the Mark-On-Belt assembly, or pull the MOB sensor
back into the original position if the CD685-3 procedure was performed. Store the
plunger back in the front cover.
Service Quick Reference Guide - Removal & Replacement Procedures 7-177