Xerox Phaser 7700 Service Manual page 332

Removal
1. Remove the Horizontal Transport Assembly (RRP 66, on page 302).
1. Remove one screw from the Left Panel and remove.
2.
Remove five screws from the Rear Cover.
3. Clear the gear at the top of the Rear Cover and remove the cover.
4.
Open the Front Door.
5.
Remove four screws securing the front cover and remove.
6. Remove two screws from the Left Cover and lift up and out to remove.
7.
Loosen the four screws securing the Top Cover.
8. Remove the left portion of the top cover assembly.
9. Open the top door and remove the front and back screws.
10.
Pop off both straps, tilt the cover up and remove.
Note When installing the rear cover, be sure that the two cables exiting
the rear cover are properly aligned around the plastic tab in the
exit way. If not, the cables fall to the bottom of the exit way and
the cable to the horizontal transport cannot reach the cable
connector on the transport.
Service Quick Reference Guide - Finisher
11-309