RRP 74 Stacker Paper-Sensor Assembly
Figure 11-16 Stacker Paper-Sensor Assembly
Removal
1.
Loosen the thumb screw and remove the Stacker Tray.
2.
Remove the four screws securing the Stacker Paper Sensor Assembly to the
finisher.
3.
Remove two screws from the bottom of the assembly.
4.
Remove one screw on the sensor bracket.
5.
Press down on the two locking tabs located at the top of the sensor, press up on
the two locking tabs at the bottom of the sensor and remove the sensor.
6.
Remove the connector from the sensor.
Service Quick Reference Guide - Finisher
11-311