Sharp AR-C150 Service Manual page 170

2) Remove the connector, and remove the duplex paper exit detector
(S07/Ua01/P02/CLN).
∗
Clean the detector.
S07/Ua01/P03 Thermistor (lower)
1) Remove the fusing upper cover.
2) Remove the screw, the washer, and the connector.
3) Remove the screw and the connector, and remove the fusing front
paper guide unit.
Fusing front paper guide installing position:
Install so that the line mark of the fusing front paper guide comes
at the center of the mark on the fusing unit.
4) Remove the detection Thermistor (lower) (S07/Ua01/P03/CLN).
∗
Clean with alcohol.
5) Remove the Thermistor pair (lower) (S07/Ua01/P03/CLN).
∗
Clean with alcohol.
(Note) Fix the thermistor so that the thermistor harness is way from
the drive section (gear).
S07/Ua01/P03/CLN
S07/Ua01/P04 Thermostat
1) Remove the fusing upper cover.
2) Remove the screw and the connector, and remove the thermostat
(upper) (S07/Ua01/P04).
3) Remove the fusing front paper guide unit.
4) Remove the screw and the connector, and remove the thermostat
(lower) (S07/Ua01/P04).
S07/Ua01/P05 Upper cleaning roller
1) Open the paper exit/transport mechanism.
2) Remove the screw, and remove the upper cleaning roller unit.
11 – 26
S07/Ua01/P04